138排气管接合密封胶

MTWO FIZZ 138排气管安装修朴高温肢用于修夏消音器，排气管系統損坏，排气管及接尖密封。

节省了更換消音器系統成本。也使新安装更加安全。固化⌒　如悍接效果，无论表面清浩或生锈都有显著附着力，清浩生锈表面以后附着カ更好。耐一▽氧化碳气体和高温。

使用说明：

1、装置新设备:把本品涂在废〗气喉，排气管接口的内部和外部(约0.65毫米厚度) ，然后正常位置△装上。

2、修补:先清洁表面，用除锈剂▂或砂纸除去污垢，油脂，铁锈后，均匀涂在针孔及裂缝处即可成功修复。

3、破损小于3mm左∩右可以直接涂抹修复，如修复面积较大的洞时，需加底垫玻纤网，涂抹后，需怠速20分钟或隔夜干燥。

执行标准: JT/T 2003-2014

安全须知：

未固化的密封胶如█接触到眼睛，请立即用大量清水清洗并送医治疗。

请置于儿童接触不到的地方。

存储条件：

在低于25°C的阴凉避光处存脱︻并保持干燥。


138 exhaust pipe joint sealant
MTWO FIZZ 138 Exhaust Pipe Installation and Repair High Temperature Glue for Repairing Muffler, Exhaust Pipe System Damage,Exhaust Pipe and Joint Sealing.Save the cost of replacing the muffler system. It also makes the new installation safer. Curing suchas welding effect, no matter the surface is clean o rusty, it has remarkable adhesion. After cleaning the rusty surface, the adhesiois better. Carbon monoxide resistance and high temperature.
Instructions for use:
1. Installation of new equipment: apply this product to the exhaust pipe, the inside and outside of the exhaust pipe interface (about 0.65 mm thickness), and then install it in the normal position.
two。 Repair: clean the surface first, remove dirt, grease and rust with rust remover or sandpaper, and apply evenly to pinhole and crack to repair successfully. 3. Damage less than about 3mm can be directly smeared and repaired, such as repairing large holes, need to add bottom cushion glass fiber mesh, after smear, idle speed 20 minutes or overnight dry.
Implementation standard: JT/T 2003-2014
Safety notes:
If the uncured sealant comes into contact with the eye, please immediately wash it with a large amount of water and send it to a doctor for treatment. Please leave it out of reach of children.
Storage conditions:
Keep it dry in a cool place below 25°C.